XR-OP-EN
- 19 -
ADJUST SHROUDS BLADES:
1. For Shroud rubber adjustments, loosen the Nylok Nuts
(A)
on the back of the Shrouds
(SEE BELOW)
.
2. To adjust rubber to the desired height, just slide the
curtain up or down in the slits and tighten screws.
3. Reattach the Shroud to the Scrubdeck by sliding back
on and tightening the Star Knobs.
ADJUST WIPERS BLADES:
1. For Cylindrical side Wipers, open wipers by releasing
the pin. Loosen Wiper band screws
(B)
(SEE
BELOW)
.
2. To adjust Wiper to the desired height, just slide the
Wiper up or down in the slots and tighten the screws.
ADJUST SHROUDS:
1. For Shroud adjustments, loosen the Start Knobs
(C)
and remove Shroud
(SEE BELOW)
.
2. Spin the Red Shroud Adjustment Knobs
(D)
up or
down on the Shroud Support Bolt
(SEE BELOW)
.
3. Once adjusted to the proper height, tighten shrouds
back in place.
ADJUST CYLINDERICAL WIPERS:
1. To adjust the Wiper Blades on a Cylindrical Scrubdeck
machine, fi rst loosen the locking nut
(E)
(SEE
BELOW)
.
2. Turn the adjustment screw
(F)
in to raise the wipers
or out to lower the wipers. The spring
(C)
provides
tension during adjustment
(SEE BELOW)
.
FRONT:
BACK:
B
A
C
D
E
F
