![background image](http://html1.mh-extra.com/html/r-g-v/fd1025-new/fd1025-new_instruction-manual_3091079054.webp)
54
EN
MICR
O
W
A
VE O
VEN
11. Programming mode
This mode is used to assign the desired cooking time and power level to the individual num
-
ber buttons.
a. Open the door.
b. Hold down the button
1
for 5 seconds, a beep confirms access to programming mode;
PROGRAM
appears on the display.
c. Press the number button that corresponds to the preset program to be changed; the
display will show the program number and the time currently set.
d. Use the number buttons to enter the desired cooking time.
e. Then press the button corresponding to the power level you want to assign to the program
being changed (“Hold 0%”, “Defrost 20%”, “Medium 50%” or “Med-Hi 70%”). The set power
level will appear on the right side of the display. If the same power selection button is
pressed two times, the default level PL10 will be set (no value will appear on the right side
of the display). If no power level is selected, the default level will be selected (PL10).
f. If you want to change the cooking factor, press the button
X2
,
CF:XX
will appear
on the display. Press the number button corresponding to the desired value. The default
value is
CF:08
.
g. Press
Start
to save the changes. If you want to change another program, press the
number button corresponding to the program to be changed.
h. Press
Stop/Reset
or close the door to exit the programming mode.
i. If the set time exceeds the value specified in option 6, when pressing
Start
to save
the setting, 3 beeps indicate that the change was not saved.
l. Close the door, the oven will switch to
READY
mode.
m. If you select a program with a set time of “0 (zero)”, the oven will not start and a beep will
indicate the fault.
Programming mode
a. Open the door, press the
1
button for 5 seconds, “
PROGRAM
” will appear.
b. Press the
3
button,
P: 03
, will appear, after two seconds the display will show the
relative time “
: 30”
.
c. Press the buttons “1”, “2” and “5” to enter the cooking time of 1 minute and 25 seconds.
d. Press
Med-Hi/70%
to set the power level.
e. Press
Start
to save. Next time program 3 is used, the oven will start automatically
for 1 minute and 25 seconds with 70% power.
Notes
1. If there is a power failure while programming, the program being changed will not be saved.
2. To reset the program to its original values, repeat the programming operation.
3. If the
Stop/Reset
button is pressed before saving the changes (
Start
button) they
will not be saved.
Содержание FD1025 NEW
Страница 2: ......