R-Co Kingsman Marquis MQVL48BLPE2, Руководство по установке

Страница: 39 / 80

MQVL48RGB Glass Back Liner Installation Option
STEP ONE:
Remove Liner Clips and screws from inside of
firebox with a 1/4” hex driver. Discard these Liner Clips but
keep screws.
STEP TWO : Remove Screws from False Bottom and Pilot
Shield. Do NOT discard screws.
STEP THREE : Reinsert screws from Back Clip
halfway
into holes under flue in Firebox. These screws will engage
center tabs on liner.
STEP FOUR : -Suction Cups Recommended-
Engage Center Tabs of Glass Back Liner onto Screws under
flue in Firebox. Do not push back onto Firebox wall yet.
Caution -Do Not Damage Thermopile on Millivolt Units.-
NOTE: If using VLBCK48 CORNER KIT and you are NOT installing
a Glass End Panel, install Inner Liner Panel from Corner Kit before
Glass Back Liner. However, if you ARE installing a Glass End
Panel, do not install Inner Liner Panel from the Corner Kit.
GLASS BACK LINER
BACK CLIP
(DISCARD)
END CLIP
(DISCARD)
Also Included: [QTY 4] DT Screws
-MQVL48RGB - BACK PANEL KIT
Corner Filler
Corner Filler
46-9/16”
19-3/8” 19-1/16”
END CLIP
(DISCARD)
⚠
CAUTION – NOT TEMPERED GLASS-
EXTREMELY FRAGILE – HANDLE WITH CARE
TOP CENTER TABS
-BACK GLASS LINER-
-CONTINUED ON
NEXT PAGE-
39