Configuring Remote Control
To place the QuVIS Encore under remote serial control, use the following steps.
Requirements
•
Serial device or edit controller supporting either Sony or Odetics serial protocol, connected to the
Encore via 9-pin serial cable (wired straight-through).
Sony and Odetics protocol (RS-422)
Select the RS-422 A Protocol
1.
Navigate to the
REMOTE – Control
menu page.
2.
Select the RS-422 serial protocol to be used by pressing the
SELECT
button to activate list of
available protocols. Once the proper protocol option has been selected from the list, press the
SELECT
button to complete the selection.
Note:
If you select the Odetics protocol, you must also complete
step 3
to assign the directory to be used by
the Odetics protocol.
3.
(Odetics protocol only)
The Odetics protocol allows the operator to select from a list of available
clips remotely. All of the clips that reside in the directory specified by the
Odetics Clips Directory
setting are made available to the Odetics controller for playback.
IMPORTANT!
Make sure that all of the clips in the
Odetics Clips Directory
are the same format and
frame rate. Failure to do so may produce video playback or communication errors.
QuVIS Encore
Page 126
QSR Version 3.1