QR400 Manual
16
OPERATION INSTRUCTIONS
SET PRESSURE & SPRAY
When your unit arrives from the factory, the pressure controller is set at BYPASS. The pressure handle will be OUT.
To increase the pressure, you will need to wind the handle IN.
10. With the motor running, switch the controller lever to PRESS (PRESSURE). (Picture shown in BYPASS position)
11. Adjust the handle to set the desired pressure you want to spray with.
CLOCKWISE = To build pressure
ANTI-CLOCKWISE = To reduce pressure (Refer indicators on handle)
12. To direct spray/liquid to the reel/s or fire reel, open the 2-way ball valve/s (Pictured in CLOSED positions).
13. Squeeze the trigger on the spray guns to spray.
14. To close down your spray unit, repeat the above steps in reverse order.
10
QUIK TIP
To extend the life of your pressure controller, we recommend releasing the pressure from your spray unit at the end of
operation. This can be done by reducing your pressure controller handle down to ZERO, and then adjusting the handle to
BYPASS. To release the pressure in the unit, CLOSE the ball valve/s to the reel and squeeze the guns to run out any pressure
and liquid from the hoses.
12
12
11
Содержание QUIKSPRAY QR400 UTV SYSTEM
