Quick PT94, Руководство по установке и использованию

Страница: 7 / 16

7
GB
RRC PW94-PT94 - REV000A
Disabling the transmitter
The disabling of a transmitter that is in operational status can take place automatically and manually.
Automatic mode: if within 3 minutes no key has been pressed, the transmitter is disabled and the transmission LED shuts off.
Manual mode: the transmitter can also be disabled manually, without waiting 3 minutes. Keep both keys pressed for the
PW94 model and
1 2 keys for the PT94 model. The orange transmission LED will flash regularly and then shut off to
signal that the transmitter has been disabled.
Low battery signal
It is recommended to replace the battery within a short period of time if the transmission LED is red during operation. The
residual autonomy time depends on the quality of the battery used.
BATTERY REPLACEMENT
WARNING: before operating on the transmitter, make sure that the RRC radio receiver is not powered. Accidentally press-
ing a key may activate the corresponding device and create a dangerous situation.
WARNING: danger of explosion if battery is replaced with an other of incorrect type.
• Remove the transmitter base by unscrewing the four screws using a Phillips
screwdriver.
• Remove the battery from the battery holder sliding it outwards without using
metal tools.
• Insert the new battery (of the type indicate in the technical characteristics) paying
attention to polarity of the positive pole (+) as shown on the metal battery holder.
• Close the transmitter base, checking that it sits correctly in the gasket groove,
located on the front of the transmitter, in order to restore the seal.
• Tighten the four screws.
WARNING: once closed, verify that the transmitter is operating correctly.
At the end of its useful life, the battery contained in the product must be disposed of separately from other separated
urban waste. Dispose of the battery in accordance with the provisions of local law.
MODELS PW94 PT94
INPUT CHARACTERISTICS
Power supply CR2450 3V lithium battery
Absorption during transmission 13 mA
CHARACTERISTICS OF THE TRANSMITTER
Number of keys 4 4
Carrier frequency 913.7 Mhz
Modulation FSK
FCC ID O2W-TXP
GENERAL
Operating temperature from -15°C to +70°C
Dimensions (W x H x D) 60 x 47 x 23 mm
Weight (including the battery) 34 g
TECHNICAL DATA
QUICK ® RESERVES THE RIGHT TO MODIFY THE TECHNICAL CHARACTERISTICS OF THE EQUIPMENT AND THE CONTENTS OF THIS MANUAL WITHOUT PRIOR NOTICE.
TRANSMITTER
BASE
CR2450 3V
LITHIUM BATTERY
SCREWS
TRANSMITTER
FRONT
BATTERY
HOLDER
MAINTENANCE
The RRC Thruster pocket radio transmitter does not require particular maintenance. Use a soft cloth moistened with water when
cleaning it. Do not use chemical or abrasive products.
OPERATION - MAINTENANCE - TECHNICAL DATA
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) this device must accept any interference received including interference that may cause undesired operation.
F