c) Programming of Cycles (Number of Sequences of Program) to Stacker ON, of Program x
Speed and of the Subsequent Program
Condition:
Operation mode „programmed sewing“ is on, i.e. key T9 (P/M) is bright and key T10
(T/E) is dark, machine not sewing
Display showing
Cycle
programming is made via the keys L+ (number increased) or L- (number decreased)
Programming of the
speed
for the program is made via key A+ (value increased) or A- (value decreased)
Programming of the
subsequent sewing program
is made via keys D+ or D-.
d) Programming of Functions
Functions for the program x are controlled via the functional keys
-
T5
function change-over for keys
T1
…
T4
(shift key)
-
T1
chain close-off (<425> = I)
-
T5+T1
automatic change-over between program 1 and program 2 (see Item 8.2.2)
-
T2
speed during programmed sewing:
variable (treadle-controlled) when
T2
is dark
constant (automatic) when
T2
is bright
-
T5+T2
no function
-
T3
blow chain at seam end
-
T5+T3
light barrier start
-
T4
no function
-
T5+T4
piece counter on display
-
T6
vacuum at start of seam
-
T7
vacuum at end of seam
-
T8
currently no function
-
T11
chopper at start of seam
-
T12
chopper at end of seam
-
T13
presser foot position at sewing stop
-
T14
presset foot position at end of seam
-
T15
light barrier
Caution:
After programming push key T5 till LED goes out
9.1.2 Parameter Programming
9.1.2.1 Programming Level A (Operator Level)
This level is used for programming control parameters which immediately affect the operation sequence.
These are the parameters for the following functions:
- Light barrier compensation stitches
<111>
- Light barrier fade-out
<112>
- Softstart
<116>
- Stitches from start (photocell dark) to thread tension release off <540>
- Stitches from start (photocell dark) to vacuum off
<541>
- Stitches from photocell clear to vacuum on
<543>
- Seam start: stitches from photocell dark to stop
<565>
cycles
3600 00 0 1 /00 2
rated speed
subsequent sewig
program
Q-41-MSII-2-EN
9.3
02-02-21
