9.1.1 Direct Programming
Attention!
All values modified within direct programming are stored only when
a) the drive system is started or
b) key T9 (P/M) are pressed.
If the drive system is switched off via the mains power switch immediately after any
values were modified, the values set before modification will be retained!
Regardless of the programming levels, certain values can be programmed without calling up parameter
numbers - i.e. directly.
The following values can be modified by direct programming:
Stitch rating S1.x
Stitch rating S2.x
Stitch rating S3.x
Speeds for seam sections
Functions for seam sections
a) Modification of Stitch Rating S1.x, S2.x, S3.x
Display shown when "manual sewing" is ON (T9 (P/M) and T10 (T/E) not luminous)
Display showing: when "programmed sewing" (T9 (P/M) being bright, T10 (T/E) not being bright) and the
seam section are activated
The keys located below the display permit to modify the values shown:
rated stitchcount S1.x
via keys A+/A-/B+/B-
rated stitchcount S2.x
via keys C+/C-/D+/D-
rated stitchcount S3.x
via keys L+/L-
program number
via keys P+/P-
seam section
via keys S+/S-
b) Programming of Stitch Rating by „Teach-in“ (Performing Work, with <799> = 3 only)
Condition:
Key T9 (P/M) is bright
Key T10 (T/E) is bright
The machine must have performed at least one stitch before.
Activate the desired program x in the display via keys P+ or P- and the seam section to be programmed
via keys S+ or S-.
Cycle:
a) Treadle forward
Reaction: the stitchcount which has been registered up to now will be eliminated
b) Treadle returns to zero position
c) Treadle forward
Reaction: machine sews, the sewed stitches will be added in, shown in the display and registered
Correction of the value shown in the display is possible via key L+ or L-.
Q-41-MSII-2-EN
9.2
02-02-21
1 0 1 0 x x/0 1 1 2
1 0 1 0 0x/00
