Quasar CF-3211/CF-4221 User and Installation Guide
50
Upload Image by E-Mail
– Select this box in order to assign an e-mail address and configure
various parameters, as seen in Figure 46: Application – Upload Image by E-Mail. When
motion is detected, event images are sent to one of two designated e-mail addresses. Select
the number of frames for the pre-trigger and post-trigger buffers from the drop-down menu
of 1-20 frames.
Check the box for
Continue image upload
to use this option. To specify the length of time for
the upload, click on this radial button and enter the number of seconds. To upload during
the active trigger, click on this radial button. Finally, select the number of frames per second
from the drop-down menu next to
Image frequency.
Note:
Make sure that SMTP or FTP configuration has been completed. See
Send HTTP notification
– Check this box to send a notification by HTTP. Select the destination
HTTP address from the drop-down menu and specify the parameters for event notifications
by motion detection triggered. When an alarm is triggered, the notification will be sent to
one of two specified HTTP servers. See Figure 47: Application – Send HTTP Notification.
Note:
Make sure that local recording (with a microSD/SDHC card) is activated so that
this function can be implemented. See
File Name
The uploaded image’s filename format is set in this section. Select one that meets your
requirements.
Save
Click
Save
to save the motion detection settings.
