Quartz CWM 105, Техническое руководство

Страница: 19 / 26

-19-
5m HIGH CONDENSATE PUMP KIT FOR CWM (L) UNITS 55600420
ITEM QTY DESCRIPTION
1 1 Pump Assembly
This kit is for use on all versions of CWM and CWM L units and is for condensate removal where a lift of up to 5m is
required.
The pump runs on demand.
A high level alarm will switch off the cooling signal until condensate has dropped below a pre-set level.
It is easier to fit this kit before installing the unit.
IF THE UNIT HAS BEEN INSTALLED, ISOLATE THE SYSTEM BEFORE FITTING THE KIT
.
1. CABINET REMOVAL
2. FITTING THE KIT
a) Fit the pump assembly into its temporary position (Fig.1) by sliding the hooks on the pump assembly bracket into the
cut-outs on the back panel side flange.
Note: This is not the final position, but it makes installation easy.
b) Fit the sensor/filter inside the drain tray (Fig.2). Do not over tighten the screw.
Fig.1 Fig.2