Quartz CWM 105, Техническое руководство

Страница: 15 / 26

-15-
'L' INFRARED REMOTE CONTROL
• The handset should be pointed towards the unit.
• Two seconds after the last button press, the whole displayed programme is automatically transmitted.
• The unit responds with 1 beep.
• The transmit symbol
A
flashes whilst transmission is taking place.
• Displayed values may be re-sent at any time by pressing the pink
H
button twice.
1. Remote Controller Power Up
Slide down the cover and insert The initial display will show:
two "AAA" size 1.5V batteries.
COOL
HIGH FAN SPEED
TEMPERATURE
'ON' TIMER SWITCHED OFF
TIME 'OFF' TIMER SWITCHED OFF
2. Setting Cool/Heat/Dry Modes
COOL - Unit cools when required but cannot heat
DRY - Unit removes moisture by cycling cooling at low speed,
humidity is reduced, but room temperature is not changed.
FAN ONLY - No cooling or heating - fan only
HEAT - If heating is available, unit heats when required but cannot cool.
AUTO COOL/HEAT - Unit cools or heats when required (if heating is available)
3. Setting the Fan Speeds
Repeated pressing of the 'fan speed selection' button selects low, medium, high and auto speeds. In 'auto' selection, the fan runs at
high speed when there is a difference of more than 2°C between the room temperature and the set (required) temperature, and low
speed when less than 2°C.
4. Setting the Temperature
Press the ‘up’ or ‘down’ 'set temperature' button to alter the display between 16°C and 30°C.
By holding both buttons down, the display is changed between °C and °F.
5. Setting the Clock (Current time)
The ‘up’ and ‘down’ buttons must be held down for 3 seconds before they operate. Continue to hold the button down for rapid change.
6. Programming the Timer
The 24 hour timer can have one ON command or one OFF command or one ON/OFF cycle in a 24 hour period. Blank ON and OFF
timer windows indicate that the timer is not programmed.
7. Setting the ON Time