Quantum StorNext QD7000, Руководство по оборудованию

Страница: 29 / 141

1. RJ-45 connector
2. iSCSI cable
3. For each cable, insert one RJ-45 connector into a host interface port on the controller and the
other RJ-45 connector into a port on the host’s Ethernet adapter or Ethernet switch.
Note: For additional information about components, see the
NetApp Hardware Universe.
Related information
NetApp Hardware Universe
Installing a SAS cable
You must install SAS cables to be used for drive shelf (drive tray) connections or for host
connections.
About this task
Attention:
Possible hardware damage – To prevent electrostatic discharge damage to the shelf
(tray), use proper antistatic protection when handling components.
Steps
1. Put on antistatic protection.
2. Verify that you have the correct cables for SAS connections by comparing them to the cable
shown in the following figure.
1. SAS cable
2. SFF-8088 connector
Some drive shelf cabling configurations require a SAS cable with a mini-SAS (SFF-8088)
connector at one end and a mini-SAS HD (SFF-8644) connector at the other end. Cables for SAS
connections do not require SFP transceivers.
1. SAS cable
2. SFF-8644 connector
20 |