Quantum StorNext M660, Руководство по оборудованию

Страница: 50 / 86

Chapter 2: Hardware Overview
StorNext M660 Connectivity
44 StorNext M660 Metadata Appliance Hardware Guide
StorNext M662 Lattus
Cabing
Interconnect switches are used to connect the components within a
Lattus system, and are also used to connect the M662 to the Lattus
system. Two different interconnect configurations are currently
supported, a configuration with a single interconnect switch
( Figure 23 ), and another configuration with two interconnect switches
for redundancy ( Figure 24 on page 46).
Connecting the M662 to the Lattus system involves cabling Eth8 and
Eth9 10GbE ports on both MDC Nodes to the Lattus interconnect
switch.
Note: Connect to the Lattus system only after both the Lattus system
installation and configuration is complete, and the M662
installation is complete, and the ethernet ports have been
configured in the StorNext GUI.
Note: You must first configure Eth8 and Eth9 ports on the rear of the
M662 prior to cabling the M662 to the Lattus interconnect
switch(es).