Quantum Scalar 218FC, Руководство пользователя

Страница: 44 / 127

34 Configuring the Fibre Channel Subsystem
ADIC Private MIB
The following chart lists all attributes that can be specified using the ADIC private SNMP MIB. Included
with each attribute are the attribute’s read/write property and a brief description of the meaning of values
read or written.
Parameter Read/Write Description
fcConfigNodeName Read/Write Worldwide name of a collection of N_Ports that
comprise a Node.
fcConfigNodeNumNPorts Read Only Number of N_Ports that comprise the named Node.
fcConfigEnableReset Read/Write Toggle for software reset. True indicates that resetting
the product via SNMP is allowed. NOTE: each time
the product is initialized this object is set to FALSE
(i.e. it is not sticky).
fcConfigUseHardAddress
Read/Write Toggle for address configuration. True indicates that
configuration of the source ID is allowed. False
indicates that the source ID may not be changed.
fcConfigSourceID Read/Write 3 byte Source address. For arbitrated loop, this will be
the Hard Assigned AL_PA (preceded by 20 bytes).
fcConfigSCSIMode Read/Write Fibre Channel-to-SCSI mapping mode.
fcConfigTraceMask Read/Write Trace Level.
fcConfigReset Read/Write Reset the product. Setting this object to TRUE will re-
start all the software (similar to powering the product
off, then on). The reset will only take place if
fcConfigResetEnable is also TRUE. NOTE: resetting
the product will disconnect all current Fibre Channel
connections.
fcConfigCommit
Read/Write Commit the configuration values to the flash memory.
miSerialBaudRate
Read/Write The baud rate for the serial interface.
miMACAddress Read/Write Physical address (MAC address).
miethernetIPAddr Read/Write The IP address for this device.
miethernetIPNetmask Read/Write Ethernet Net Mask.
miCommunitySet Read/Write SNMP Community name for Sets. Not supported.
miCommunityGet Read/Write SNMP Community name for Gets. Not supported.
scsiConfigTable Read/Write A Table containing SCSI Configuration parameters.
scsiConfigEntry Read/Write An entry in the SCSI Configuration Table.
scsiConfigIndex Read Only Index into the SCSI Configuration Table.
scsiConfigInitID Read/Write Initiator SCSI ID.
scsiConfigTargetIDAdd Read/Write Set this SCSI target ID.
Parameter Read/Write Description
scsiConfigTargetIDRemove
Read/Write Remove this SCSI target ID. The SCSI ID you specify
will no longer be a target.