Quantum Scalar 218FC, Руководство пользователя

Страница: 31 / 127

Configuring the Fibre Channel Subsystem 21
Notes
You may have to set the Bits per second (baud rate) in the
COM2 Properties dialog box to a higher value to establish
serial communications between your Scalar 218FC and your
computer. If the Configuration Program main menu
does not
appear after pressing
ENTER
several times, change the baud
rate to the next higher value and repeat step 11. Continue
increasing the baud rate until the menu appears.
The
Build Level: a9802
in the main menu is the current
version of fibre channel subsystem firmware installed in your
Scalar 218FC.
Configuring the Fibre Channel Interface
Introduction
The Scalar 218FC Configuration Program allows you to control many configuration settings through the
fibre channel serial interface or through the Ethernet connectivity capability. Among these are:
Baud rate of the serial port
Fibre Channel configuration
SCSI configuration
Ethernet configuration
Fibre Channel-to-SCSI mapping
Trace level settings
The default configuration settings of the Scalar 218FC are adequate for most applications. Configuration
settings may be changed and saved. They become the new default settings the next time you start your Scalar
218FC.
Repeatedly press
ENTER
on the host computer until the Configuration Program main menu appears on the
monitor:
ADIC FCR100/CP4100 Fibre Channel/SCSI Router Configuration
Build Level: a9802
1) Perform Configuration
2) Do a Trace Dump
3) Reboot
4) Download a New Revision of the Firmware
Command >