Quantum Scalar 218FC, Руководство пользователя

Страница: 38 / 127

28 Configuring the Fibre Channel Subsystem
the current Scalar 218FC Fibre Channel IP Address
the current Scalar 218FC Fibre Channel IP Subnet Mask.
The operations to change these values are described below.
Ethernet Physical Address. The Ethernet Physical Address is sometimes referred to as the MAC
address. It is a unique 48-bit value that is based on a vendor ID assigned by the IEEE. To change the Scalar
218FC’s physical Ethernet address:
1. Press 1 while in the Ethernet Configuration Menu. The Configuration Menu displays the following
prompt:
Enter new Ethernet Physical Address >
2. Enter your new Ethernet physical address and press Return .
If you enter an invalid Ethernet address, the Serial Interface displays the following error:
ERROR:
Invalid Ethernet Address!
Press Any Key to Continue...
3. Press X to return to the Configuration Menu.
4. Press A to save the new Ethernet Address.
IP Address. The IP address is used by the TCP/IP protocol to route information in a TCP/IP network. A
systems administrator usually assigns the IP address. To change the Scalar 218FC Internet (IP) address:
1. Press 2 while in the Ethernet Configuration Menu. The interface displays the following prompt:
Enter new IP Address >
2. Enter the new IP address and press Return .
If the IP address you specify is invalid, the following error message is displayed:
ERROR:
Invalid input!
Press Any Key to Continue...
3.
Press X to return to the Configuration Menu.
4. Press A to save the new IP Address.
IP Subnet Mask
The IP subnet mask is used by TCP/IP protocol to establish a path to a default TCP/IP gateway. A systems
administrator usually assigns this value. To change the IP subnet mask:
1. Press 3 while in the Ethernet Configuration Menu. The following prompt is displayed:
Enter new Subnet Mask >
2.
Enter the new IP subnet mask and press Return .
If you enter an invalid IP subnet mask, the following message is displayed:
ERROR:
Invalid input!
Press Any Key to Continue...
3. Press X to return to the Configuration Menu.
4. Press A to save the new IP subnet mask.