Quantum DLT 2000, Руководство по эксплуатации продукта

Страница: 49 / 345

Configuring and Operating the DLT2000 Basic Tape Drive
DLT2000/DLT2500/DLT2700 Cartridge Tape Subsystem 3-11
3.5 Description of Controls and Indicators
Section 3.5 includes the following sections:
Topic Section
Beeper 3.5.1
Unload Button 3.5.2
Cartridge Insert/Release Handle 3.5.3
Indicator Action during Power-on Self-test and
Operation 3.5.4
3.5.1 Beeper
A beeper sounds when you can operate the cartridge insert/release handle. When you
hear the beep, the green Operate Handle light should be on. To prevent damage to the
drive wait for the sound of the beeper before opening the door!!
3.5.2 Unload Button
The Unload button is used primarily to unload the tape. When the user pushes Unload,
the DLT2000 waits until an active write to tape is completed before beginning the
unload sequence.
The drive then rewinds the tape back into the cartridge. The tape must be completely
rewound and unloaded into the cartridge before you can remove the cartridge from the
drive. An unload operation may take 20 seconds from BOT.
If the drive is in error state (all right-side lights are flashing on the front panel), pushing
the Unload button causes the drive to reset and unload the tape if possible.
3.5.3 Cartridge Insert/Release Handle
Operate the cartridge insert/release handle to load a cartridge or to eject a cartridge only
when the Operate Handle light is on, and after the momentary beep sounds. The handle
lifts to the open position and lowers to the closed position. See Section 3.7 and Section
3.9 for the operating procedures.