Quantum ATL 7100, Руководство по установке

Страница: 46 / 68

Chapter 3 Installing the Library
Connecting the Library to the Host Controller
30 Quantum|ATL 7100 Series Facilities Planning and Installation Guide
4
Connect one library-to-host SCSI cable to the library rear panel
(see
figure 11 ) at SCSI PORT 1.
5
Install the SCSI terminator (provided in the accessories kit) for
host SCSI cable 1 on the rear panel connector labeled
SCSI
PORT 2 .
6
Connect the other library-to-host SCSI cable to the library rear
panel at
SCSI PORT 3 .
7
Install the SCSI terminator (provided in the accessories kit) for
host SCSI cable 2 on the rear panel connector labelled
SCSI
PORT 4 . Refer to figure 11 .
8
On the library rear panel, set the
POWER
button to the “
|
” (on)
position.
9
After several seconds, verify that the SDA shows System On-
line.
10
Apply power to all other SCSI targets connected.
11
Apply power to the host.
Note:
Figure 11 shows a two-wire, four drive configuration.
If you are using a different configuration, the cable
connections will be different. See Appendix A for
more information about different configurations.