Quadro6L/4L Manual I: Installation Guide
Hardware Overview
Hardware Overview
The Connectors Panel of Quadro6L/4L
The illustration below includes the connector’s panel of Quadro6L model.
Fig. l- 1: Connectors Panels of Quadro6L IP PBX
The illustration below includes the connector’s panel of Quadro4L model.
Fig. l- 2: Connectors Panels of Quadro4L IP PBX
1.
Power supply socket. Use only the power adapter delivered with the Quadro.
2.
LINES sockets to connect the Quadro to the PSTN network using standard ana-
log phone service. These are FXO (Foreign Exchange Office) analog ports.
3.
The Reset button may be used in two ways: (1) to initiate a normal reset or (2) to
carry out a factory reset. A normal reset is executed by pressing the Reset but-
ton with a paper clip for an instant.
Pressing the reset button and holding it down for seven seconds or more will
execute a factory reset. This will restore the factory defaults and clear all settings
including the IP address and the administration password you entered.
Please Note:
A Factory Reset forces the default LAN IP address of 172.30.0.1
and default admin password of 19.
4.
RJ45 socket to attach to the Local Area Network (LAN) via an Ethernet CAT 5
cable. If a PC is connected directly to this socket, a straight cable is used. If an
Ethernet hub, router or switch is used; a crossover cable may be required. This
port may also be used to connect IP phones to the Quadro (optional). In this
case, it is recommended to use a hub or a switch to connect the PC along with IP
phones to the Quadro’s LAN port.
Quadro6L/4L; (SW Version 5.2.x)
8
Содержание Quadro6L
Страница 1: ......
