Quadro6L/4L Manual I: Installation Guide
Step 2: Configuring the Quadro
Step 2-A: Using IP Lines
Before starting the IP Lines configuration, the appropriate IP phone should be connected to
the Quadro either through its WAN or LAN port. If the phones are placed on the Quadro
WAN, which the default configuration assumes, please ensure that the Connect IP phones
from WAN side checkbox is enabled on the Line Settings page (see Fig. l- 32).
The Quadro6L/4L provides two options for configuring IP phones:
•
The Plug-and-Play option is available for supported SIP phones only. The list of
these phones is given
below
. The Plug-and-Play option does not require any
specific configuration except that the Enable PnP for IP lines checkbox should
be enabled on the Line Settings page (see Fig. l- 32).
•
The Auto-Configuration option is available for tested and supported SIP
phones. The list of tested SIP phones is given
below
. The Auto-Configuration
option (described in detail below) requires specifying some basic parameters on
the Quadro and restarting the phone.
Please Note:
With the both options, IP phones download their configuration from the Qua-
dro’s TFTP server. Therefore, if the phones obtain their network parameters from a DHCP
server other than the Quadro’s built-in DHCP server, please ensure that either the server
does not provide the “TFTP server” parameter or the parameter is set to the Quadro’s LAN
or WAN IP address depending on the location of IP phones.
When using the automatic-configuration option, each IP line should be configured individu-
ally from the Telephony menu, Line Settings page.
Open from the Telephony menu and choose Line Settings page. The IP Line Settings
page is displayed.
Fig. l- 32: Line Settings page
Quadro6L/4L; (SW Version 5.2.x)
32
Содержание Quadro6L
Страница 1: ......
