4
Step 4: Install Rear Door Surrounds
to Jeep
Locate the assembled Driver’s
side rear door surround (Fig 10). On
the bottom of the vertical pillar portion
of the assembled door surround are
two pins that will be inserted into the
body tub as shown in FIG11.
Insert this pin into the body tub as shown
in FIG’s 12 &13. Repeat this procedure
on the passenger side rear door sur
-
round.
FIG 10
FIG 11
FIG 12
FIG 13
Step 5: Secure Front & Rear Door
Surrounds to the Roll Bar
Locate
the two sets of screw knobs and the
driver’s side front and rear door sur
-
rounds. There should be 2 sets of
four knobs. These knobs go
i
n the
front and rear holes of the Brackets
previously installed in step 3 on the
door surrounds.
FIG 15
FIG 1
4
Line up the front driver’s side door
surround bracket holes with the
vertical holes in the over door
horizontal roll bar. Slip the front two
knobs through the brackets holes in
the front door surround (FIG14)
lining it up with the hole in the top of
the surround bracket on top of the front
horizontal roll bar. If you use a rolling
motion while you push the brackets on
it will be easier to install. Loosely tight
-
en each of the knobs securing the front
door surround.
Note:
if you have difficult lining up the top of
FIG 1
3a
FIG 1
3
b
the knobs with the upper bracket hole,
rotate the bottom of the door surround pin
out of the body tub slightly towards you and
start the knob. Rotate the pins back into the
tub and tighten knob. You can also remove
the installed top brackets covering the top
hole to get a better view of how the screw
lines up. Fig 13a & 13b. Repeat on the
passenger side of the vehicle.
