20
September 27, 2018
7082-153D
TREKKER INSERT
Figure 20.3 - Shown with Cast Panel Set
Basic
Cast
Attach Trim to Base
from underneath
Attach Trim to Insert from
inside Insert.
Install Front Trim Last,
Corner Overlap Side
Trim Pieces
5 in
3 in
5 inch
high Set
3 inch
high Set
Location of Latch
for Removing
Cast Sides
Lower the leveling
bolts if necessary to
keep the insert level
when installing the
Hearth Support.
Remove the cast side by releasing the upper, spring-loaded
latch. Access the latch through the upper panel vent holes.
The cast panel should fall forward. Lift it out of its lower
nest and set the panel aside.
Figure 20.1
9 attachment holes - 3 on
each side and 3 in the front
Figure 20.2
Included in Surround Kit:
(2) side panels, left and right;
(1) panel top; (1) fastener package.
Included in Cast Trim Kit:
(2) cast trim legs, left and right;
(1) cast trim header; (2) cast trim footers, left and right; (1)
fastener package.
Tools Needed:
Powered Phillips head screw driver
1. Remove contents from box being careful not to scratch
or damage the cast trim pieces.
2.
Lay the surround set face down on protective covering
to prevent scratching the painted surface.
3. Secure the surround legs to top panel with the screws
provided.
4. Now bend the tabs down toward the backside of the
panel set, 5 on top and 2 on each leg. Leave the panel
set face down
(Figure 20.4)
.
5. Place the corresponding cast trim pieces ( 2 cast trim
legs and 1 cast trim header) underneath the panel set,
also face down.
6. Place washer provided over tab and secure the trim
and panel together with screw. Continue for all tabs.
7. Secure cast footers with screws.
8. Remove both left and right cast sides from insert
(See
Figure 20.3)
.
9. Carefully slide surround and trim over the top of the
insert into place matching the mounting holes on the
panel with the mounting holes on the insert. Secure
with screws provided.
Figure 20.4
Figure 20.5- Completed View
1. Screw panels
together
2. Bend tabs down
1. Screw panels
together
3. Install Cast Trim Header
2. Bend tabs
down
D. Removal of Cast Sides
E. Surround & Cast Trim Set
