6
September 27, 2018
7082-153D
TREKKER INSERT
NOTE:
Upon removing the appliance from the fireplace
a tag shall be permanently attached to the
fireplace indicating it has been altered and
should be inspected by a qualified person prior to
re-use as a convectional fireplace (tag included
in component pack).
B. Tools And Supplies Needed
Tools and building supplies normally required for
installation, unless installing into an existing masonry
fireplace:
• Reciprocating Saw
•
Channel Locks
• Hammer
•
Phillips Screwdriver
• Tape Measure
•
Plumb Line
•
1/4” Self-Tapping Screws
•
Framing Material
•
Hi-temp Caulking Material
• Gloves
• Safety Glasses
•
Framing Square
•
Electric Drill & Bits (1/4”)
•
Level
May also need:
Vent Support Straps
Venting Paint
Risk of Fire!
• Damaged parts could impair safe operation.
•
Do NOT install damaged, incomplete or
substitute components.
WARNING
WARNING
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
• Installation and use of any damaged appliance.
•
Modification of the appliance.
• Installation other than as instructed by Hearth &
Home Technologies.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
•
Operating appliance without fully assembling all
components.
•
Operating appliance without legs attached (if supplied
with appliance).
•
Do NOT Over fire
Or any such action that may cause a fire hazard.
C. Inspect Appliance and Components
•
Open the appliance and remove all the parts and
articles packed inside the Component Pack. Inspect all
the parts and glass for shipping damage.
• Report to your dealer any parts damaged in shipment.
• All labels have been removed from the glass door.
•
Plated surfaces have been wiped clean with a soft
cloth, if applicable.
• Read all the instructions before starting the
installation. Follow these instructions carefully
during the installation to ensure maximum safety
and benefit.
• Follow pipe manufacturer instructions for
installation and air clearance requirements.
