Quadra-Fire TREKKER-CSB, Руководство пользователя

Страница: 7 / 36

April 18, 2018 7080-166B 7
TREKKER
Model Trekker Pellet Stove
Laboratory OMNI Test Laboratories, Inc.
Report No. 061-S-83-2
Type Solid Fuel Room Heater, Pellet Fuel
Burning Type
Standard ASTM E1509-12, ULC S627-00 and
(UM) 84-HUD, Mobile Home Approved.
FCC Complies with Part 15 of FCC Rules.
Operation is subject to the following two
conditions: (1) this device may not cause
harmful interference, and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
The Quadra-Fire Trekker Pellet Appliance meets the U.S.
ENVIRONMENTAL PROTECTION AGENCY Certified to
comply with 2020 particulate emission standards at 0.74 G/
HR EPA CFR subpart AAA, using ASTM E2779-10, ASTM
2515-11 Method- Pellet Appliance sections, CSA B415.1-10.
This pellet appliance needs periodic inspection and repair for
proper operation. It is against federal regulations to operate
this pellet appliance in a manner inconsistent with the oper-
ating instructions in the owner’s manual.
Emissions Report Number: 0061PS094E
EPA Certification #: 98-17
EPA Certified Emissions: 0.74 g/hr
*LHV Tested Efficiency: 83.2%
**HHV Tested Efficiency: 77.9%
***EPA BTU Output: 39,428 / HR
****BTU Input: 50.775 / HR
Vent Size: 3, 4 or 6 inches, “L” or “PL”
Hopper Capacity: 80 lbs.
Fuel Wood Pellets
* Weighted average LHV efficiency using data collected during
EPA emissions test.
** Weighted average HHV efficiency using data collected during
EPA emissions test.
*** A range of BTU outputs based on HHV and the burn rates
from the low and high EPA tests.
****
Based on the maximum feed rate per hour multiplied by
approximately 8600 BTU’s which is the average BTU’s from a
pound of pellets.
• Installation and use of any damaged appliance.
• Modification of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
• Operating appliance without fully assembling all components.
• Operating appliance without legs attached (if supplied with
unit).
• Do NOT Over fire - If appliance or chimney connector glows,
you are over firing.
Any such action that may cause a fire hazard.
1
Listing and Code Approvals
A. Appliance Certification
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifications and/or price without notice.
NOTICE: This installation must conform with local codes. In
the absence of local codes you must comply with the ASTM
E1059-12, ULC S627-00, (UM) 84-HUD and ULC/ORD-
C-1482.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified
installer, service agency or your dealer.
Quadra-Fire is a registered trademark of Hearth & Home
Technologies.
WARNING
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be voided by,
the following actions:
B. BTU & Efficiency Specifications
C. Glass Specifications
This stove is equipped with 5mm ceramic glass. Replace
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
D. Electrical Rating
115 VAC, 60 Hz, Start 2.9 Amps, Run 2.45 Amps
E. Mobile Home Approved
• This appliance is approved for mobile home installations
when not installed in a sleeping room and when an out-
side combustion air inlet is provided.
• The structural integrity of the mobile home floor, ceiling,
and walls must be maintained.
• The appliance must be properly grounded to the frame
of the mobile home and use only Listed pellet vent Class
“L” or “PL” connector pipe.
• Outside Air Kit (OAK-3) must be installed in a mobile
home installation.