Quadra-Fire SANTAFE-MBK, Руководство по установке

Страница: 22 / 28

22 7050-145L August 3, 2018
SANTA FE FREESTANDING
D. Thermostat Installation and Operation
The kit comes with a programmable wall thermostat and
25’ of thermostat wire. If you need to run more than 25’
make sure you use a continuous strand of 18 to 22 gauge
thermostat wire. For optimum performance your thermostat
should be:
• Mounted on an inside wall, approximately 5’ above the
floor
• Do not locate where there is poor air circulation such
as in a corner, alcove, behind doors, bookcase or other
objects
• Located away from drafts, direct sunlight, above a
lamp, television, radiator, a wall next to a window, or
direct heat from the appliance
• Avoid damp environments as this can lead to corrosion
that may shorten thermostat life
• If painting or construction work around, cover the
thermostat completely or wait until work is complete
before installation.
Shock hazard.
• Do NOT remove grounding prong from
plug.
• Plug directly into properly grounded 3
prong receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of
appliance.
CAUTION
Figure 22.1
Figure 22.2
Figure 23.3
1. Separate the body of the thermostat from the mounting
plate by gently pulling the two pieces apart (Figure
22.1)
2. Use a drill with either a 3/16 drill bit for drywall or a 7/32
drill bit for plaster drill holes.
3. Using a hammer tap in wall anchors.
4. Route the wires through the opening in the base plate,
and hold the base against the wall while aligning up
to the holes. Attach base plate using a Phillips head
screwdriver and two screws.
5. Connect your thermostat wire to the W and R terminals
(Figure 22.2) .
W R
W R
Appliance
BATTERY BATTERY
NOTE:
Ensure bare wire ends are held ALL the way into
the terminal block while the screws are being
tightened.
6. There are two AA ALKALINE ONLY batteries already
installed into the thermostat; to activate, remove
black plastic tab that is located inside the battery
compartment.
7. Snap the thermostat to the base plate.
TERMINAL BLOCK
CENTER 2 SCREWS FOR
THERMOSTAT WIRES
POWER OUTLET
There is a 4 screw terminal block located on the back lower
left corner of the appliance directly above the power cord
inlet. The center 2 screws are for the thermostat wires (see
Figure 22.4
).
Figure 22.4