Page 30
October 24, 2011
Castile & Santa Fe CE Pellet Stove
R
7068-112B
A. Outside Air Kit Instructions
(Shown on SANTA FE)
Flex Hose
Hose Clamp
Collar Assembly
Trim Ring
Termination
Cap Assembly
Hose Clamp
Air Intake Channel
(Discard)
Parts Included in Kit:
1 piece of 51mm x 914.4mm flex
hose, 2 hose clamps, 1 air intake channel1 collar assembly,
1 termination cap assembly, 1 trim ring, 12 screws. (Discard
air channel it is not need for this appliance).
1. Measure distance from floor to air vent opening in stove
and mark location on wall.
Use saw to cut opening in wall. Cut a 64 to 76mm open
-
ing on inside wall and a 76 to 89mm opening on outside
of house.
2. Remove cover plate and then install the collar assembly.
3. Use hose clamp to secure flex pipe to collar assembly.
4. Slide trim ring over flex pipe and run pipe through wall.
5. Attach hose to outside termination cap with second hose
clamp.
6. Secure termination cap to outside surface.
7. Secure trim ring to interior wall.
Tools Needed:
Phillips head screwdriver; wire cutters; hole
saw or jig saw.
CAUTION
Never draw outside combustion air from:
• Wall, floor or ceiling cavity
• Enclosed space such as an attic or garage
Figure 32.2
Termination Cap
Hose Clamp
Trim Ring
Flex Hose
Collar
Assembly
Figure 32.1
9
Appliance Set-Up
