24
7037-172
September 26, 2016
4300 Wood Appliance Series ACC
H. Adjusting The Blower Speed Control
The blower speed control for this unit is adjusted at the factory,
and normally does not require further adjustment.
1. With the appliance plugged in, turn the speed control
knob to slow (full clockwise).
2. With a small screwdriver, adjust the blower speed by
turning the adjustment mechanism through the hole on
the side of the speed control.
3. Adjust the speed so the blower runs slowly, but does
not stop. Turn clockwise to slow the blower and
counterclockwise to increase the speed.
NOTE:
When the speed control is turned clockwise, it will
click on to high speed. Continue to turn the speed control
clockwise to decrease the speed. At full clockwise, the blower
should blow gently, but should not stop.
G. Blower (Optional)
Tools Required:
#2 Phillips head screwdriver
1. Locate bolts supplied with the blower.
2. Align holes in mounting flange of blower with bolt holes in
appliance. Blower should be positioned at bottom of rear
outer skin as shown in
Figure 24.1
3. Re-insert and tighten bolts, securing blower onto outer
wall of appliance.
4. Place the bracket containing the snap disc and magnet
under the bottom left rear corner.
See
Owner’s Manual
for detailed operating instructions
for the blower and snap disc.
Shock Risk
.
• Do NOT remove grounding prong from plug.
• Route cord away from appliance.
•
Do NOT route cord under or in front of appliance.
• Plug directly into properly grounded 3 prong receptacle.
CAUTION
Figure 24.1
Snap Disc
Bracket
with
Magnet
Secure wires
with wire tie
MANUAL
FAN
AUTO
LOW
HIGH
OFF
MANUAL:
Over-rides
the Snap
Disc
AUTO: Fan
will turn
ON/OFF
Automatically
by the Snap
Disc
Controls
the Fan
Speed
