Qtum HD1049, Инструкция по установке и эксплуатации

Страница: 36 / 89

36
HD1049 installation and user manual
PLAYBACK FOLLOWING TIME CHANGE
The DVR uses the time and date to index video on the hard disk drive so you can find it later.
Changing the time can cause the DVR to work improperly, when you try to play back video. If
you set the hour ahead, this is not a problem. But, if you set the hour back, there will be more
than one recording with the same time stamp.
Such as during the October Daylight Saving Time changeover, if you try to search for video
between 1 am and 2 am, the recorder may not operate properly because there will be two
hours of recorded video during this time period. To view video during this overlapping time
period, you must start playback before 1 am, then recorder will play both hours between 1
am and 2 a.m.
You cannot do a backward search through the overlapping time. But, you can do forward
search.
The Time and Date and the DST time can be changed from the front panel, the Mouse or the
Remote Control
Video Type
Video Type can set in this menu without rebooting or initialisation. The default is PAL, NTSC
can also be selected
System ID
The remote control can be used to control up to 16 DVRs, the ID number on each can be set
to a unique address so that the remote will only control one at a time if they are in close
proximity. The default is 11.
Repeated click on the ID value to change to the required number.
To select a unit on the remote control press the ID button,
followed by the number, followed by the ID button again.
The LED will flash slowly.
Initialization
All the menu settings will be returned to the factory default. To carry out this function the
system recording will have to be turned off.
LED