Hardware Installation
3. Product Installation
90
www.qtech.ru
3.6
Mounting the Cabinet
Precautions
When you install the cabinet, pay attention to the following:
❖
All expansion bolts for fastening the cabinet base to the ground should be installed and
tightened in sequence from bottom up (large plain washer, spring washer, and nut), and
the installation holes on the base and the expansion bolts should be well aligned.
❖
After the cabinet is installed, it should be stable and still.
❖
After the cabinet is installed, it should be vertical to the ground.
❖
When multiple cabinets are put side by side in the room, they should be aligned in a
straight line, with an error less than 5 mm.
❖
The front/back doors of the cabinet should be properly installed. You can open and close
them smoothly. The locks should work normally, and all keys should be complete.
❖
There should be no unnecessary formal labels inside the cabinet and on various boards.
❖
Blank panels should be installed completely.
❖
Fastening screws of various devices in the cabinet of the same model should be ready and
tightened.
❖
Various boards of the equipment should be installed securely, and the fastening screws on
the panel should be tightened.
❖
All wiring inlets at the top and bottom of the cabinet should be installed with rodent-
resistant nets where the seams should be no more than 1.5 cm in diameter, to prevent
rodents and other small animals from entering the cabinet.
❖
Antistatic wrist straps should be provided in the cabinet.
Installation Steps
1.
Reserve sufficient space for front and back doors of the cabinet for maintenance.
2.
Mount the cabinet at the designed location as planned.
3.
Install the appropriate cable management bracket and cables.
4.
Install the tray and wiring layer on the rack according to the configuration of one rack with
one cabinet installed or one rack with multiple cabinets installed.
