QSW-6200
Series Switch Hardware Installation and Reference Guide
33
www.qtech.ru
Remove the power module uprightly and slowly.
Install a baffle in the location where the power module is removed to ensure the normal ventilation and dissipation
and avoid the dust in the chassis.
Installing an QSW-M-6200-PWR2 Power Module
Step 1: Take a new power module out of the package and confirm the input mode and the input parameters of the power
module match the requirements.
Step 2: Remove the power baffle and take the plane printed with power information as the top panel of the power module.
Hold the handle of the power module with one hand, and hold the end of the power module with the other hand. Insert it
into the chassis along the guide rail uprightly and slowly until a click is heard, and make sure that it is in good contact with
the power slot. The three screws are the input terminals of the DC power module. Remove the screws, and then put the
ends of power cables in place before driving the screws back. From left to right, cables are blue, red and yellow-green.
Then, remember to cover the terminals with protective caps.
Step 3: Connect the other ends of power cables to the DC panelboard: connect the blue one to the -48VDC terminal, the
red one to -48VGND, and the yellow-green one to PGND.
Figure 3-7 Installing a Power Module
Figure 3-7 Connecting Power Cables to the DC Panelboard
