9
d.
Try moving your finger or pen across the board and make sure the mouse cursor is in
sync with either of them. If not, use the arrows on the calibration box above to adjust for
any deviation and click OK.
e.
If you have calibration problems even after you calibrate, especially around the corners of
the board, it is possibly a projector problem. The projector could either be too close or too
far from the board, minimize the use of keystone adjustment and zoom, and always
manually adjust the image to fit within the frame of the board. There are indicators on the
board that guide where the image shall project. If your board has hot keys then ensure
that the projector image is between the markings on the bottom right and top left of the
board. The projector image should not exceed those markings. If this problem continues
to exist, please contact technical support.
4)
Board damage
Sometimes the board may experience damage due to mishandling during shipping or improper
storage which may prevent the board from connecting to the computer or may cause the cursor to
skip during writing. Please contact QOMO support who can help you detect if the circuit boards
are bad or address uneven board surface issues.
www.Qomo-Europe.eu
