Qilive Q.1660, Руководство пользователя

Страница: 11 / 88

11
EN EN
lit. A new code can then be entered.
• Setup mode is automatically closed approximately 30 seconds if no button is
used. The Status LED (2) will blink 3 times then go off.
5.4. Learning Function
This remote control has a learning function. This enables you to transfer the functions of
your original remote control to this universal remote control.
Notes before launching the learning function:
• Make sure that all of the batteries used in the two remote controls are in good
condition. Change them if necessary.
• Place your original remote control and the universal remote control close to each
other
• If needed, adjust the position of the two remote controls for optimal alignment.
• There should be a distance of approximately 3 cm between the two remote
controls.
• Do not move the remote controls during the learning process.
• Ensure that the room is not lit with fluorescent tubes or energy saving lamps, as
they may cause interferences and impede the learning process.
• There should be a distance of at least 1 metre between the two remote controls
and the closest light source.
• The learning process is completed without saving if no button is used for 30
seconds or if no signal is received while learning mode is activated.
• In learning mode, only one function per button can b allocated. A new function
replaces the previous functions recorded for this button.
• You cannot allocate new functions to the TV, DVD, STB, SOUND, AUX, DVBT
and SETUP bottons.
Learning mode activation
1. Simultaneously press the [MUTE] (22) and [VOL+] (6) buttons for
approximately 3 seconds until the Status LED (2) comes on solidly.
2. Use the device selection button to select the device (e.g. [TV]) that a new
function should be learned for. Once a selection has been successfully
made, it’s confirmed by the Status LED (2) blinking once then staying lit.
3. Enter the code [9] [8] [0], and the Status LED (2) will blink twice then stay
solidly lit.
4. The universal remote control is now in learning mode.
NB:
• If the Status LED (2) blinks 8 times and the learning mode ends automatically, this
means that too many buttons have already learned functions and that the memory
available is full. The remote control can memorise up to 125 learned buttons.
• If no device is selected, the latest device selected is automatically used.
Transferring the button function
1. Press the button on the original remote control that you want to transfer
the function for. To confirm that the command has been received, the
Status LED (2) on the universal remote control will blink.
2. Now, press on the button on the universal remote control to which you
want to transfer the function.
3. The Status LED (2) on the universal remote control will blink 3 times to
confirm, then it stays solidly lit. The new function has now been saved.
4. To transfer the functions of other buttons, repeat these steps.
5. Press the [SETUP] button (9) to save all learned functions and exit
learning mode.