6
QEES A/S - Naverland 2,14 sal. - 2600 Glostrup - Denmark - (+45) 81 41 10 10 - www.qees.eu
3.
Then switch your primary controller to “exclusion mode” to remove your
MyKey from network. Please consult the relevant controller’s manual on how
to reach “exclusion mode”;
4.
Your MyKey lights green for 2 seconds and is subsequently removed from
your existing Z-Wave network.
Inclusion in Z-Wave network &
Association of new products to controller groups
In order to remotely control any device you need to include it into your wireless Z-
Wave network and associate it to one of the MyKey groups. Please take note that each
group is mapped to a button (e.g. group 1 is mapped to button 1, group 2 is mapped to
button 2, etc.)
1.
Press 3 times quickly on the button that you want to use for controlling your
device (the LED lights blue)
2.
Then press 3 times quickly on the
QEES
device you want to control –
QEES
device lights purple and it will begin linking.
3.
After successful linking between the MyKey and the device, both LEDs will
glow green for 2 seconds.
4.
To assign more than one device to one button just make sure that you follow
the same steps as above.
5.
After the linking is finished the device(s) can be controlled wirelessly from
your MyKey button. A single press will turn your product on or off. Keep the
button pressed down to adjust the light intensity (only for Z-Wave dimmers).
6.
By repeating steps 1-3 you can add multiple devices to other buttons on your
MyKey.
For non-
QEES
devices the MyKey behavior is the same. You need to put your non-
QEES device in learn mode and for this please refer to their manual for the procedure
“Activating Z-Wave Learn Mode”.
Note: If MyKey is acting as a secondary controller in the Z-Wave network then it can
not include other Z-Wave devices. In this case triple pressing one of the buttons will
only perform the association process described below.
Association of existing products to your MyKey groups
Here we have the same 3 steps that we used for association of new devices to group
:
1.
Press 3 times quickly on the button you want to use to control the device;
2.
Then press 3 times quickly on the device which is already added to the
network-the device lights purple and it begins linking;
3.
After successful linking between MyKey and the device, both LEDs will glow
green for 2 seconds;
4.
The device can now be controlled wirelessly from your MyKey;
5.
For non-
QEES
products please refer to their manual at the section “Network
Inclusion” in order to complete the inclusion process.