9
QEES A/S - Naverland 2,14 sal. - 2600 Glostrup - Denmark - (+45) 81 41 10 10 - www.qees.eu
4.
During the controller shift procedure MyKey will attempt to replicate any
application data (groups) transferred by the primary controller using the
Controller Replication Command Class.
Note:
During the controller replication procedure MyKey will accept only
group information from the primary controller. It will ignore the scene
information transferred by the primary controller. Accepting also scene
information will be available in a future software release.
Resetting MyKey
You can
reset default settings
on your
QEES
MyKey by going in the Blue Menu and
selecting the purple option. This procedure will delete all associations and scenes
made on MyKey.
Another type of reset is the
Hardware Reset
and it can be done by keeping pressed
down for approximately 40 seconds button 4 of your MyKey. This procedure will reset
the device if it behaves erratically or does not respond to actions keeping the
associations and scenarios made on MyKey.
Bridge Mode
When plugged into the USB port MyKey goes into the Bridge Mode State. In this state
the device will expose a serial port interface to the PC and can be used with a PC
software application called QEES PC Controller.
You can exit Bridge Mode and return to Controller Mode by pressing any button. The
device will automatically go back to the Bridge Mode after 60 seconds of inactivity.
Software Update
As all other
QEES
devices
QEES
MyKey can be upgraded with new features when a
new firmware is released. In order to do this you must follow the next sequence of
steps:
1.
Connect your MyKey to the computer through a USB port. Depending on the
operating system you will either be asked to install a driver for this device
automatically or you will need to do it manually;
2.
Install QEES PC Controller software freely provided by
QEES
(you can find
the installer and the installation instructions on
3.
Put your MyKey in USB Update mode by pressing down any two buttons
while the device is making one of the charging-related feedbacks (charging or
charged). The LED will light solid green once in USB Update mode;
4.
Refer to the QEES PC Controller documentation on how to upload the new
firmware image on MyKey.
Interoperability and Certification
All QEES Z-Wave devices are Z-Wave Certified. This guarantees that QEES Z-Wave
devices will be interoperable in a network with other third party Z-Wave Certified
devices. Every mains powered device can be used as a repeater inside a Z-Wave
network.
Supported CCs:
Basic Command Class