3
QEES A/S - Naverland 2,14 sal. - 2600 Glostrup - Denmark - (+45) 81 41 10 10 - www.qees.eu
allowing you to operate your device with simplicity, instead of forcing you to
memorize convoluted combinations of button-press patterns.
There are four main points you need to focus on:
1.
How to make the selection;
2.
The Menu Selection Point;
3.
The Action Selection Point;
4.
LED Color Guide.
1. How to make a selection
Menu Selection
– once you have decided on a menu click on MyKey button 2 and
hold the button in order to select it. While you keep the button pressed the LED will
switch off and will flash the menu color and show the first action color (usually cyan).
Action Selection
- you need to press and hold MyKey button 2 once you reached the
option you decided upon (remember you need to be inside a menu for this to happen).
As you hold the button pressed the LED will turn off and the device will start
performing the selected action, along with the relevant feedback for it.
2.
Menu Selection Point
To get to the menu selection point you need to hold pressed any two buttons on your
QEES MyKey. You know that you have reached the menu selection point if you see
white LED feedback. Here you can cycle through all the menu options by clicking on
button 3 for “cycle up” and button 4 for “cycle down” (note: each click will show a
different color representing a different menu):
1.
Purple – Scene Management;
2.
Green – Controller Options;
3.
Blue – Network Options;
4.
Red – Menu Exit – this option takes you out of the menu selection point.
3. Action Selection Point
You have decided on a certain menu and selected it as described above. Once you have
selected the menu you enter the Action Selection Point. You can now zap through
different actions by clicking MyKeys buttons 3 or 4 (cycle up or down between
actions). To select a certain action press and hold MyKey button 2 until the LED turns
of then release. Each action option has a specific LED feedback as described below:
Example: Blue Menu
1.
Get controller type – blue flash followed by cyan color
2.
Start Z-Wave learn mode – blue flash followed by yellow color
3.
Restore default settings – blue flash followed by purple color
