26
www.quantumrehab.com
Quantum 1107
V . C O M F O R T A D J U S T M E N T S
Foot Platform Angle
You can adjust the angle of the foot platform with a hex
key. See figure 22.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the setscrew.
2. Turn the setscrew anticlockwise to raise the front of the
foot platform.
3. Turn the setscrew clockwise to lower the front of the
foot platform.
Controller Position
You can position the controller for either left-hand or right-
hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or the power base frame.
To change the controller position:
1. Turn off power to the controller.
2. Disconnect the controller from the power base.
3. Cut the wire tie(s) that attaches the controller cable to
the armrest.
4. Flip up the armrest and loosen the setscrew. See
figure 23.
5. Slide the controller out of the armrest.
6. Loosen the setscrew in the other armrest.
7. Place the controller in the other armrest.
8. Tighten the setscrew to secure the controller.
9. Use a wire tie to secure the controller cable to the armrest.
10. Plug the controller into the power base. See figure 6.
Swing-away Footrests
Swing-away Footrests (SFRs) enable you to rotate the
footrests to the side before you transfer onto or off of
your power chair.
To rotate the SFRs:
1. Push in the release lever. See figure 24.
2. Rotate the SFRs.
To adjust the SFR length:
1. Remove the two adjustment screws from the side of
each footrest extension. See figure 24.
2. Slide the footrest up or down to the desired length.
3. Reinstall the two adjustment screws.
Figure 22. Underside of Foot Platform
SETSCREW
Figure 23. Underside of Armrest
Figure 24. Swing-Away Footrests
FOOTREST
ADJUSTMENT
SCREWS
FOOTREST
EXTENSION
SFR RELEASE LEVER
SETSCREW
