40
www.quantumrehab.com
Quantum 1107
NOTE: When the batteries approach a discharged state, the first red light will begin to slowly flash, reminding
you the batteries need to be charged immediately!
Right/Left Turn Indicator Keys (Optional)
The right/left turn indicator keys toggle either the left or right turn indicators. Press once to turn on and press again to turn
off. You can also turn off the selected turn indicator by pressing the opposite indicator key or the hazard key.
Light Key (Optional)
The light key turns the headlights/taillights on and off independent of other indicators.
Hazard Key (Optional)
The hazard key activates both turn indicators at the same time. You can only cancel this by pressing the hazard key again.
Power Accessories/Power Accessory Indicator (Optional)
If your power chair is equipped with power accessories such as a power seat or power elevating leg rests, you can operate
them through the keypad. The power accessory indicator indicates the selected power accessory. Contact your Quantum
Rehab Specialist for more information.
Off-board Charger/Programming Socket
The off-board charger/programming socket is located on the front of the Remote Plus. If you use an off-board charger, the
charger current should not exceed 8 amps. Contact your Quantum Rehab Specialist for more information.
WARNING! Only chargers with Neutrik NC3MX plugs should be connected to the off-board charger/
programming socket. See your Quantum Rehab Specialist for more information.
Controller Communications Cable
The controller communications cable provides the Remote Plus with a connection to the power module.
Sleep Mode
Your Remote Plus controller has a sleep mode feature. Sleep mode is a built-in circuit that automatically shuts off the
main power if the joystick is not moved in any direction for approximately five minutes. The battery condition meter
lights on the keypad indicate sleep mode by blinking once every five seconds. To restore power and continue, push the
on/off key twice.
Thermal Rollback
The Remote Plus is equipped with a thermal rollback circuit. This circuit monitors the temperature of the motors, power
module, and remote. In the event that any of them become excessively hot (above 122° F), motor voltage is reduced.
For every degree above 122° F, the voltage is reduced by 5 volts. This reduces your power chairs speed and allows
the electrical components to cool down. When the temperature returns to a safe level, your power chair resumes its
normal speed.
V I I . O P E R A T I O N
