Q.VITEC Imagechecker Q.400PD, Руководство по оборудованию

Страница: 33 / 65

Product description
32
the power supply. Disconnect all peripheral devices. Before you begin, en-
sure that you have a clean, flat and ESD-safe surface to work on.
1. Close all applications and shut down the system properly
2. Disconnect the power cord from the power supply
3. Disconnect all peripheral devicess
The system should lay on a flat, clean surface with the front panel facing down-
wards. Make sure that the display surface is protected against scratching and
damage.
4. GN07: Unscrew the screws that secure the cover
GN10/12/15: Unscrew the screws that secure the metal cover on the optional in-
terface area
5. Remove the cover and put it aside
For GN07, proceed to step 6. For GN10/12/15: Pull the mechanical adapter with the
RS422/RS485 from the case.
6. Locate the DIP switches in the unit
7. By use of an insulated thin tool (e. g. screwdriver or a stylus) set the DIP switches
to the up (for ON) or down (for OFF) position corresponding to the port configu-
ration required
The default port configuration is RS485 2-channel mode (see p. 23) with timeout.
8. Put the cover back on
9. When the cover is firmly in place, fasten the screws