Under frequency/channel mode, press [FUN]+[0ANI] key, the screen will show
“ANI?”, press [ENT] then turn the channel switch to select “OFF/ON”, select “OFF”
It means the ANI function is off, select “ON” it means ANI function is on. After
selection press [ENT] key to confirm, press [VFO/MR] key to exit.
Identification code (ANI), can be programmed by software to two ways:
①
Before
TX,
②
End TX; There are two signaling for choose: MSK, DTMF
KEYPAD LOCK SETTING
Under frequency/channel mode, press [FUN]+[9SET] key to enter the menu mode,
turn the channel switch to select “MANUAL” “AUTO”. After selection press [ENT]
Key to confirm and press [VFO/MR] to exit.
TIME OUT TIMER(TOT)
Continuous transmission may damage the radio, and the radio allows to set a time
limit for transmission among OFF/30-270S. When time limit expires, the radio may
Give a warning tone.
Under frequency/channel mode, press [FUN]+[9SET] key to enter the menu mode,
turn the channel switch to select the eleventh item, the screen will show “TOT?” press
[ENT] key and turn the channel switch to select “OFF-270”, select “OFF” it means
TOT function is off. After selection press [ENT] to confirm and press [VFO/MR] to
exit.
SCAN MODE
Under frequency/channel mode, press FUN+[9SET] key to enter the menu mode, turn
the channel switch to select the twelveth item, the screen will show “SCAN?” press
[ENT] to confirm, you can select the three types: TO,CO,SE.
Time Operation mode (TO)
When the radio detects a signal, it will pause scanning and remain the current status
for 5 seconds, and it will go on with the scanning even if the signal still exists.
Carrier frequency mode (CO)
When the radio detects a signal, it will stop scanning and stay on the same frequency
till such signal disappears. There is 2 seconds latency between the disappearance of
signal and continuing to scan.
Search scan mode (SE)
When the radio detects a signal, it will stay on the frequency or channel of such signal
and exit scanning.
VOICE GUIDE FUNCTION