PURSUIT 3480 Drummond Runner, Руководство пользователя

Страница: 23 / 130

3480 DRUMMOND RUNNER
23
2.6 Engine Stop Switch
WE STRONGLY RECOMMEND THAT THE LANYARD BE ATTACHED TO THE DRIVER
WHENEVER THE ENGINES ARE RUNNING.
Your Pursuit is equipped with an engine stop switch and lanyard. When the
lanyard is pulled it will engage the switch and shut off the engines. If the
engines will not start, it could be because the lanyard is not properly inserted
into the engine stop switch. Always make sure the lanyard is properly attached
to the engine stop switch before attempting to start the engine.
WEAR THE LANYARD AT ALL TIMES WHILE OPERATING
YOUR BOAT. USE IT TO STOP ONLY IN AN EMERGENCY,
NOT TO SHUT OFF THE ENGINE DURING NORMAL OP-
ERATION.
Refer to the engine owner's manual for more information on the engine stop switch.
2.7 Steering System
The steering system is hydraulic and made of two main components: the helm assembly and the hydraulic
cylinder. The helm unit acts as both a fluid reservoir and pump. Turning of the helm, or steering wheel, pumps
the fluid in the hydraulic hoses and activates the hydraulic cylinder causing the motors to turn. A slight clicking
sound may be heard as the wheel is turned. This sound is the opening and closing of valves in the helm unit
and is normal. Refer to the steering manufacturer owner’s manual for specific information on the steering
system.
Dual engine outboards are coupled at the tiller arms by a tie bar. The engines must be aligned with each other
to provide maximum stability on straight ahead runs and proper tracking through corners. Engine or steering
system damage may require the engines to be realigned.
SOME AUTOPILOTS HAVE ENGINE POSITION SENSORS THAT ARE MOUNTED TO THE
HYDRAULIC STEERING CYLINDER. WITH THESE AUTOPILOTS, THE ENGINE POSI-
TION SENSOR BRACKET COULD HIT THE TRANSOM WHEN THE ENGINES ARE TILTED
TO THE FULL UP POSITION AND CAUSE DAMAGE TO THE ENGINE RIGGING, THE
AUTOPILOT OR THE TRANSOM. IF YOU HAVE AN AUTOPILOT INSTALLED ON YOUR
BOAT, YOU SHOULD MONITOR THE LOCATION OF THE ENGINE CABLES AND AUTO-
PILOT BRACKETS AS THE ENGINES ARE TILTED TO DETERMINE THE BEST ENGINE
POSITION AND MAXIMUM ENGINE TILT FOR YOUR APPLICATION.
TILT HELM
A tilt helm may be installed on the 3480 Drummond Runner. To tilt the wheel, depress the lever located in
the base of the helm. Make sure it locks into position.
Engine Stop Switch