PURSUIT 2665 DENALI, Руководство пользователя

Страница: 66 / 137

2665 DENALI 66
Sun Lounge/Bench Seat
9.3 Cockpit Equipment
IN CERTAIN CONDITIONS, OPEN EXTERIOR DOORS AND HATCHES THAT ARE NOT
SECURED PROPERLY CAN SLAM CLOSED UNEXPECTEDLY AND CAUSE INJURY TO
PASSENGERS OR DAMAGE TO THE BOAT. MOST DOORS AND HATCHES ARE
EQUIPPED WITH SPECIAL FASTENERS, HATCH LIFTERS, OR SNAPS AND/OR
STRAPS, TO SECURE THEM IN THE OPEN POSITION. ALWAYS MAKE SURE THAT
THESE HATCHES AND DOORS ARE PROPERLY SECURED WHENEVER THEY ARE IN
THE OPEN POSITION.
Helm Seat Base
The helm seat is mounted on a seat base module with storage, tackle lockers, a stern facing
lounge/bench seat, battery compartment and two fire extinguishers.
The two person helm seat is equipped with an electric ram activated by switches at the helm that
move the seat forward or backward. Always make sure the seat is in the full aft position before
opening the helm.
The battery compartment is located in the forward section of the seat base. The compartment
accommodates three batteries that are accessed through a hatch on the front side of the base, below
the helm seat.
The cockpit table and pedestal are stored in a large drawer in the rear of the seat base. The table
pedestal mounts to a pedestal base located in the rear of the cockpit, on the fishbox hatch. The
motion of the boat can damage the table and pedestal when it is under way. They should be
properly stored in the drawer before operating the boat above idle speed.
The rear facing bench seat converts to a sun
lounge. To convert the seat to a lounge,
release the latch just below the port corner of
the rear seat cushion and slide the rear seat
base out. To convert the lounge to a bench
seat, lift the center cushions slightly, and then
push the seat base toward the front of the
lounge until the seat backs are in the upright
position. The spring latch will automatically
lock when the seat is in the full up position.