PureLink by Dtrovision
13
7. Now you have the IP Address shown on the screen
8. The cursor will be located on the first set of numbers of the default IP Address
9.
Use the ‘Create’ and ‘Preview’ button to change numbers
10. a. To go from left to
right, use ‘Out1’ button
b. To change numbers up and down, use ‘Create’ and ‘Preview’ buttons
c. To move to the second set of numbers on the IP address, Press
‘
Out1
’ button
(Note: Data will not go higher than 255 for any of the column or it will show error screen if you go higher)
11. After configuring to the correct IP Address, press Enter button
12. Select '6 LAN Config Upload' and Press enter button twice to save the IP setting
**Use same method to change Gateway, Subnet Mask IP Address.
**Using Dynamic IP
1. Press Menu
2. Select '3.LAN Set'
3.Select '1.IP Config'
4. Press 'Create' or 'preview' button to select 'Dynamic IP(DHCP)' and Enter
5.Select '6. LAN Config Upload' and press Enter twice.
*Default IP setting for the UX is Dynamic IP
Factory Reset
Factory reset will put the general setting back to the factory default mode.
Factory default setting value:
RS-232 Baud rate:
19200 Bps
IP Address:
Does not change
Gateway:
Does not change
Input/output Connection:
No Connection
Product ID:
255
All Video/Audio switching connection becomes clear
Serial communication setting will be restored back to the factory default
Baud Rate: 19200, Data Bits: 8, Parity: None, Stop Bits:
1
LAN Communication settings will not be changed from previous setting
