HDBaseT 4x4 Matrix Switcher-N
19
%9962.
Check the status while in standby mode.
%9963.
Check the working mode of infrared carrier.
%9964.
Check the IP address (
only for the PCB with GUI
).
%9971.
Check the connection status of the inputs.
%9972.
Check the connection status of the outputs.
%9973.
Check the HDCP status of the inputs.
%9974.
Check the HDCP status of the outputs.
%9975.
Check the switching status.
%9976.
Check the output resolution.
%9977.
Check the status of digital audio of output channels.
%9978.
Check the HDCP status of the input ports.
Note
:
1)
Please disconnect all the twisted pairs before sending command EDIDUpgrade[X].
2)
In above commands, “[”and “]” are symbols for easy reading and do not need to be
typed in actual operation.
3)
Please remember to end the commands with the ending symbols “.” and “;”.
4)
Type the command carefully, it is case-sensitive.
5.3.2 Control the HDBaseT 4x4 Matrix Switcher-N
To control the HDBaseT 4x4 Matrix Switcher-N, you need to connect its 9 pin female
RS232 port to PC’s RS232 port, or you can just connect any one of the HDBaseT
receiver’s RS232 port with PC (RS232 command transmits to the HDBaseT 4x4 Matrix
Switcher-N via the twisted pair). By using RS232 control software and setting right
specifications, you are able to control the HDBaseT 4x4 Matrix Switcher-N.
Control the HDBaseT 4x4 Matrix Switcher-N from local
Control the HDBaseT 4x4 Matrix Switcher-N from local
