HDBaseT 4x4 Matrix Switcher-N
15
Command
Types
Command
Codes
Functions
System
Command
/*Type;
Inquire the models information.
/%Lock;
Lock the front panel buttons on the Matrix.
/%Unlock;
Unlock the front panel buttons on the Matrix.
/^Version;
Inquire the version of firmware
/:MessageOff;
Turn off the feedback command from the com port. It
will only show the “Switch Ok”.
/:MessageOn;
Turn on the feedback command from the com port.
Demo.
Switch to the “demo” mode, 1->1, 2->2, 3->3 … and
so on .The switching interval is 2 seconds.
Undo.
To cancel the previous operation.
Operation
Command
[x]All.
Transfer signals from the input channel [x] to all
output channels
All#.
Transfer all input signals to the corresponding output
channels respectively.
All$.
Switch off all the output channels.
[x]#.
Transfer signals from the input channel [x] to the
output channel [x].
[x]$.
Switch off the output channel [x].
[x]@.
Switch on the output channel [x].
All@.
Switch on all output channels.
[x1] V[x2].
Transfer the AV signal from the input channel [x1] to
the output channel [x2].
[x1] B[x2].
Transfer the AV and IR signal from the input channel
[x1] to the output channel [x2].
Status.
Inquire the input channel to the output channels one
by one.
Save[X].
Save the present operation to the preset command
[X], ranges from 0 to 9.
Recall[Y].
Recall the preset command [Y].
Clear[Y].
Clear the preset command [Y].
PWON.
Work in normal mode.
PWOFF.
Enter into standby mode and cut off the power
supply to HDBaseT receivers.
STANDBY.
Enter into standby mode.
