HDBaseT 4x4 Matrix Switcher-N
12
Note: When switch all the 4 IR input signal channels to a same IR out channel,
it is not able to control the controlled device(s) at the same time.
2) IR Carrier Enforcing
a)
Only if the IR receiver connected with HDBaseT receiver is with IR carrier, the
received IR signal can be transferred to IR OUT port of the matrix.
b)
Only if the IR receiver connected with IR
ALL IN
port of the matrix is with IR carrier,
the received IR signal can be transferred to IR OUT port of the matrix.
If the IR receiver connected with HDBaseT receiver or IR ALL IN port of the matrix is
not with IR carrier, you need to send the command “
%0901.
”, and then you are able
to transfer the IR signal to IR OUT port.
3) Control far-end output device from local
When need to control a remote displayer from local, the IR receiver used must be with
IR carrier. The IR signal is transferred to the corresponding zone connected with
HDBaseT receiver connected with the
IR transmitter
. When the
IR receiver
is
connected to IR ALL IN port, the IR signal can be finally transferred to all the 4 IR
transmitters connected with HDBaseT receivers.
As the figure below:
Control far-end device from Local
