PTI PX 300, Инструкция по эксплуатации, Страница: 24 / 35

Page 24
Step 10
Center Section
Build the Center Section
A:
Place wax paper on your building surface Locate the “Center Section” from the
CENTER SECTION SHEETING
sheet. Place this on your surface.. BE SURE ITS flat you’ll probably need to clamp it
B:
Locate the “Radio box sides”, “Rear Radio Box Bulkhead”, “Nose Doublers” and “Former “C”, test fit as shown
C:
Locate the “Transom Doublers” and Glue together.
D:
Test fit in place as shown
E:
With all the formers radio box bulkhead and transom doublers in place, tack glue all parts
F:
Finishing adding formers, note extra long tabs, glue into place
G:
Install “Front Radio box bulkhead” use masking tape to hold in place
H:
Locate 1 piece of 1/8” square basswood strip as shown in B, place out strip as shown in picture F
I:
Be sure the square is in the notch in the transom , using a razor saw trim the length of the stick as shown
Center Section bottom
Radio Box sides
Front Radio box bulkhead
Nose Doublers
Rear Radio Box
Bulkhead
Transom Doubler
Transom Doublers