PSC PowerWedge 10, Руководство пользователя

Страница: 30 / 116

Programming the PowerWedge 10
25
PowerWedge
®
10
1. Connect a bar code reader to the connector labeled
INPUT
1 on the
programmed PowerWedge 10 (the “master”), and set the On/Off/
Program switch to the
ON
position (see
Figure 1
).
2. Scan the following bar code:
*$+$-EC*
This puts the programmed PowerWedge 10 into cloning
mode. While the decoder is in cloning mode, the red and
green light-emitting diodes (LEDs) alternate flashing twice
(that is, the flashing sequence is green-green-red-red,
green-green-red-red, and so on).
3. Remove the bar code reader from the master, and connect one end
of the cloning cable (part number 00-874-25) to
INPUT
1 on the
master.
NOTE
Cloning will work only if the master and slave are the same model. For exam-
ple, you cannot use a PowerWedge 10 Serial as the master and a keyboard
wedge model or a Mini PowerWedge as the slave.
NOTE
You can also use the bar code menu on the bottom of the PowerWedge 10 to
enter cloning mode. Scan the labels for
START
,
E
, and
C
, in that order.
NOTE
You can also use the bar code menu on the bottom of the PowerWedge 10 to
enter cloning mode. Scan the labels for
START
,
E
, and
C
, in that order.