Charging (using optional 9.6V rechargeable Ni-Cd batteries)
In case your prefer to use rechargeable batteries, the charging jack is located on the
back side of control panel where "12
V
" or "Charge" is marked. Before start
charging, make sure the
9.6V (1.2V X 8)
rechargeable NiCd batteries are installed
and the power switch is set to OFF position. It is important that you use only the
DC 9.6V charger
that is specifically designed for charging your Ni-Cd batteries. Do
not attempt to charge Ni-Cd batteries with any common voltage adopters. They
typically have incompatible electrical characteristics which can cause harmful
effects on the batteries and on your Husky. Using incompatible charger also poses a
fire hazard. We recommend using a Ni-Cd battery charger which do not exceed the
following specification:
Input voltage
: 110V 60 Hz for USA, 230V 50 Hz for Europe
Output voltage
: DC 9.6V 150 mAh
Charging jack polarity :
NOTE
Never attempt to charge alkaline or non-rechargeable batteries. It can damage the
unit and cause the battery electrolyte to leak and cause additional damages and injuries.
Power Switch (ON, OFF, S/B)
The Power switch is the small toggle switch located back of the Control Panel. It
can be set to On, Off or Standby (S/B) mode. Power On and Off is the same as any
other electronic devices. Standby (S/B) mode allows you to program all functions
without transmitting a radio signal. This is useful for making adjustments while not
affecting others that may be on your frequency. Standby (S/B) mode also uses
about 2/3 less power. If you plan to work in a programming mode for any length of
time or use your Husky as a PC game controller, using Standby will extend your
battery life. " " appears on the LCD display in Standby (S/B) mode.
Preparation
ADV
50 : FM 40.665 MHz 10.3 V
SHIFT : POSITIVE
1 : ALL
STB
D/R
STA
IDL
ABS
SST
Standby
9
STB
