3.0 Mounting
The Protégé® EliteSuite® Eclipse LED Keypad maintains complete control of your residence.
All the actions performed in your security system will be executed through the Protégé® EliteSuite®
Eclipse LED Keypad. It is intended to be mounted on a wall.
Step 1
Select where to mount the Protégé® EliteSuite® Eclipse LED Keypad.
Step 2
Remove the rear half of the Protégé® EliteSuite® Eclipse LED Keypad by depressing the retaining
clip and rotating the case halves apart.
Step 3
Hold the rear case half against the wall and mark the mounting holes and cable entry area.
The cable entry area should align with a hole cut through the plaster wall-board. Cables are
intended to be run inside the wall. Use appropriate screws (not supplied) to affix the case to the
wall.
Step 4
Run the wiring. Refer to later sections of this manual for the electrical connections. Leave about
20cm (8”) of wire protruding through the center of the mounted half of the case.
Step 5
Connect the wiring to the Protégé® EliteSuite® Eclipse LED Keypad electronics, then, to clip the
case together, hook the top edges together then rotate and press the bottom in until you hear the
clip snap into place.
4
