Protac PRoX-2622, Руководство пользователя

Страница: 90 / 91

Appendix C Trouble Shooting
Prox-2622 USER
′
S MANUAL
Page: C-7
3E :
Try to turn on Level 2 cache.
Note : Some chipset may need to turn on the L2 cache in this stage. But
usually, the cache is turn on later in POST 61h.
BF :
1. Program the rest of the Chipset‘s value according to Setup. (Later Setup
Value Program).
2. If auto-configuration is enabled, programmed the chipset with pre-defined
value in the MODBINable Auto-Table.
41 :
Initialize floppy disk drive controller.
42 :
Initialize Hard drive controller.
43 :
If it is a PnP BIOS, initialize serial & parallel ports.
45 :
Initialize math coprocessor.
4E :
If there is any error detected (such as video, kb....), show all the error
messages the screen & wait for user to press <F1> key.
4F :
1. If password is needed, ask for password.
2. Clear the Energy Star Logo (Green BIOS only).
50 :
Write all CMOS values currently in the BIOS stack area back into the CMOS.
52 :
1.Initialize all ISA ROMs.
2. Later PCI initializations (PCI BIOS only).
-assign
IRQ to PCI devices.
-initialize all PCI ROMs.
3.PnP Initializations (PnP BIOS only).
-assign I/O, Memory, IRQ & DMA TO PnP ISA devices.
-initialize
all PnP ISA ROMs.
4. Program shadows RAM according to Setup settings.
5. Program parity according to Setup setting.
6. Power Management Initialization.
-Enable/Disable
global PM.
-APM interface initialization.